The switch is in the "OFF" position.
The LED light has burned out(see maintenance section
for the replacement procedure).
The wine cooler is unplugged.
The home circuit breaker or fuse has tripped.
The wine cooler does not have the correct clearances.
The door gasket does not seal properly.
The temperature control is not set correctly.
The door is not closed completely.
The door is opened too often.
A large amount of warm wine has been added to the
wine cooler.
The room temperature is hotter than normal.
The wine cooler does not have the correct clearances.
The door gasket does not seal properly.
The door is not closed completely.
The door is opened too often.
External environment may require a higher setting.
Wine cooler is
not cold enough.
The circuit breaker tripped or blown fuse.
Wine cooler does
not operate.
PROBLEM
TROUBLESHOOTING GUIDE
You can solve many common wine cellar problems easily, saving you the
cost of a possible service call. Try the suggestions below to see if you can
solve the problem before calling the servicer.
Troubleshooting
POSSIBLE CAUSE
Not plugged in.
Check to be sure the temperature control setting.
Compressor turns
on and off frequently
The light does
not work.
8
The shelves are out of position.
The gasket is dirty.
The wine cooler is not level.
The wine cooler is not level.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your wine cooler.
The rattling noise may come from the flow of the
refrigerant,which is normal.
Check to assure that the wine cooler is level.
Vibrations.
The wine cooler
seems to make
too much noise.
The door will not
close properly.
Technical Specifications:
For detailed specifications, please refer to the nameplate at the back of the
wine Cooler. The specifications are subject to change without prior notice
due to products Improvement.
