07-04 / 46001669 / EN
6.- Once you have selected the desired options, press the START key (H). The washing machine
will start up and one of the time remaining or programme phase lamps (V) will come on. This
lamp indicates approximately how much time is left before the wash programme is completed
(or wash cycle phase): it will change as the programme progresses. Make sure that the stop/end
of cycle lamp is flashing before pressing the start key (H). If it remains on continuously, turn
the programme selector to OFF and re-set it to the desired programme.
To cancel an option after setting, just press the option key again (the indicator lamp will
go out).
To change or cancel a programme
once the programme selected has started,
proceed as
follows:
- Hold down the start key
(H)
until the stop/end of cycle lamp is burning steadily. The
programme has been cancelled, and another may be selected.
- Select the new programme.
- Press the start key
(H)
again until one of the time remaining or programme phase lamps
lights up.
- The machine will then run the new programme selected.
Programme Pause
To pause the wash programme
so that more washing can be added
, proceed as follows:
- Hold down the start key (H) until the option key lamps begin to flash and the time remaining
or programme phase lamp lights up.
- When the Door Lock lamp goes out (after approx. 2 minutes), open the door and put the
additional washing into the drum.
- Close the drum door and the lid properly.
- Press the start key
(H)
, the time remaining or programme phase lamp will light up and
the machine will continue with the programme.
When the programme is completed the Stop/End of cycle lamp (S) will come on and the time
remaining or programme phase and Door Lock lamps (V and G) will go out.
For your own safety, set the programme selector to OFF before opening the washing-
machine lid and the drum doors to remove the washing.
