Hoover HSXS5085, Service Manual

Page: 47 / 255

Turn the water On at the shutoff valve.
Tighten any connection that leaks.
Replace the access cover and tighten all screws
(on some models).
Turn the Water On
Plug in the refrigerator to the Power Outlet and
turn
On .
IMPORTANT: Always operate the Refrigerator from a
power source of the same Voltage, Frequency and
Rating as indicated on the Refrigerator
Identification Plate. Operate the Refrigerator from
an Earthed (Grounded) 3 Pin Power Outlet fully
accessible when the refrigerator is located in its
normal operating position.
Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall.
Push the refrigerator back to the wall, making sure
the power cord and the water line tubing are not
trapped, entangled or squashed by the refrigerator
(including the wheels) or wall.
Plug In the Refrigerator
Set the icemaker power switch to the I position.
The icemaker will not begin to operate until it
reaches its operating temperature of –9°C or below.
It will then begin operation automatically if the
icemaker power switch is in the
I position.
NOTE: In lower water pressure conditions, the water
valve may turn on up to 3 times to make sure
enough water reaches the icemaker.
Start the Icemaker
Power
switch
32