INSTALLATION GUIDE
ABOUT ELECTRICITY CONNECTING
Page 4
Built-in Dishwasher
WARNING
!
For personal safety:
Do not use an extension cord or an adapter plug with
this appliance.
Do not, under any circumstances, cut or remove the
earthing
Connection from the power cord.
ELECTRICAL REQUIREMENTS
ELECTRICAL CONNECTION
!
Insure proper ground exisits before use
COLD WATER CONNECTION
Ensure the voltage and frequency of the power being
corresponds to those on the rating plate. Only insert
the plug into an electrical socket which is earthed
properly. If the electrical socket to which the
applance must be connected is notappropriate for
the plug, replace the socket, rather than using a
adaptors or the like as they could cause overheating
and burns.
!
WARNING!
Please close the hydrant after using
Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is fastened
tightly in place.If the water pipes are new or have not
been used for an extended period of time, let the water
run to make sure that the water is clear. This precaution
is needed to avoid the risk of the water inlet to be
blocked and damage the appliance.
POSITIONING THE APPLIANCE
Position the appliance in the desired location. The
back should rest against the wall behind it, and the
sides, along the adjacent cabinets or walls. The dish-
washer is equipped with water supply and drain hoses
that can be positioned either to the right or the left
sides to facilitate proper installation.
HOW TO DRAIN EXCESS WATER FROM HOSES
If the sink is 1000 higher from the floor, the excess
water in hoses cannot be drained directly into the
sink. It will be necessary to drain excess wate
from hoses into a bowl or suitable container that
is held outside and lower than the sink.
WATER OUTLET
Connect the water drain hose. The drain hose must be
correctly fitted to avoid water leaks. Ensure that the
water inlet hose is not kinked or squashed.
EXTENSION HOSE
If you need a drain hose extension, make sure to use
a similar drain hose. It must be no longer than 4
metres; otherwise the cleaning effect of the dish-
washer could be reduced.
SYPHON CONNECTION
Insert the drain hose into a drain pipe with a minimum
diameter of 40mm, or let it run into the sink, making sure
to avoid bending or crimping it.
The top of the hose must be less than 1000mm.
START OF DISHWASHER
The following things should be checked before starting
the dishwasher
1)
The dishwasher is level and fixed properly
2)
The inlet valve is open
3)
Inlet hose connections are fully tightened and not
leaking
4)
The wires are tightly connected
5)
The power is switched on
6)
The inlet and drain hoses are knotted
Please look at the rating label to know the rating volage
and connect the dishwasher to the appropriate power
supply. Use the required fuse 10 amp, time delay fuse or
circuit breaker recommended and provide separate
circuit serving only this appliance.