Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Changing the programme
If the appliance is switched
off during a wash cycle.
WARNING!
Switch on the appliance
Open the door,press the On/Off button to switch on the appliance .
Quick operation guide
Quick operation guide
For detailed operating method read the corresponding content on the instruction manual.
4
Fill the detergent dispenser
The detergent container is inside the door.
If the lid of the container is closed, press
the button
(A)
to open.
At the end of every wash cycle the lid is
always open and ready for the next time
the dishwasher is used.
B
.
B
.
Mechanical indicator B
.
Mechanical indicator B
.
It is always advisable to use rinse aid that is specifically designed for dishwasher.
Check the rinse aid level through the indicator eye
(B)
which is located on the dispenser.
T urn on the water tap ,close the door . The machine will start working after about 10 seconds.
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid
handling the dishes and utensils while they are still hot and more susceptible to break.
The dishes will also dry better. First start unloading the lower basked.
To load the baskets, refer to the section entitled
Loading the Dishwasher Baskets .
Press the Programme Button until the selected programme lights up.
( See the section entitled
Operation instruction
)
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door.
3. Press the
Programme Button
for more than 3 seconds to cancel the running programme.
4. Select a new programme.
5. Restart the dishwasher.
Open the door carefully.
Look out for hot steam
when opening the door!
Adding forgotten dishes in
the dishwasher.
Summary of Contents for HDI 2T1045
Page 11: ......
Page 15: ...Means need to fill rinse into the Rinse Aid Dispenser...
