background image

10

11

OTHER

FLOOR EXTENSION TOOL - 14.4V (HH5010WD) ONLY

CARE AND CLEANING (cont)

BATTERY CARE AND DISPOSAL

Wall Mounting

Your Hoover HandiVac comes with a specially designed bracket used to hold the recharging base 

so that it may recharge while mounted on wall.
1.   To mount the bracket, place it against the wall for the desired position, trace the mounting 

holes of the bracket using a sharp pencil, onto the wall or mounting surface. Make sure the 

wall bracket is vertically positioned.

2.  Drill a diameter hole into each of the marked hole. Insert a plastic anchor into each hole.
3.  Drive one screw into the upper anchor leaving the screw slightly exposed.
4.   Place the bracket on the exposed portion of screw, slide the bracket downward to let the 

screw go into the slot.

5.   Insert the second screw through the bracket into the lower anchor, tighten it to secure the 

bracket.

NOTE:

 Care must be taken when drilling into walls.

NOTE:

 There are two different wall mount charging bases depending on your model purchased.

The Hoover HandiVac 14.4 comes with a Floor extension tool.  

This allows your hand-held vacuum to reach difficult spaces 

such as down small spaces, ceiling cornices, along shelves 

or simply down to the floor.
The four parts assemble easily. Insert the Inlet Fitting (part 

iii) into the inlet of the hand-held vacuum. This will fit firmly 

in place. Then take the two extension tubes (part ii) and join 

together. Once together, one end will then fit into the Inlet 

Fitting (part iii). Finally push the soft brush (part i) into the 

open end of the extension Tube (part ii). You are now ready  

to extend the use of your hand-held vacuum.
These extra parts are 

able to conveniently 

store on the special 

Floor extension Tool 

storage adaptor to 

your Charging base – 

as shown in Figure 2.
Figure 3 shows 

extension Tool 

assembly.

Your hand-held vacuum comes with a rechargeable battery pack inside. The battery pack must 

not be modified or changed. Any servicing required on the battery pack must only be undertaken 

by an authorised Hoover Floorcare service agent. Please visit www.hooverfloorcare.com.au for 

your closest agent.
At the end of life of this appliance, we suggest the battery pack is removed and disposed of in 

accordance with your local municipal guidelines.

 This product contains recyclable materials. Do not dispose of this product as 

unsorted municipal waste. Please contact your local municipality for the nearest 

collection point.

Fig. 5

Fig. 1

Fig. 3

Fig. 2

(i)

(ii)

(iii)

Summary of Contents for HandiVac 14.4








Reviews: