● After the initial charge, discharge the battery fully and charge until the indicator light
turns OFF, max. 6 hours.
MAXIMIZING THE LIFE OF YOUR LITHIUM-ION BATTERY
● Do not store the unit with the charging adapter attached and plugged in.
● Do not store in areas of high temperature or humidity.
● Use only the charger supplied with the product. If other chargers are used, the
batteries can fail causing damage to the battery, product or personal property.
● After 3 months of non-use, the product should be fully discharged and then
recharged to maximize battery power.
● If the product has never been used or has been stored for an extended period of time
without use - it will take several complete charge and discharge cycles to realize the
full operational time of your product.
ASSEMBLY OF THE HAND VACUUM
IMPORTANT:
The dust cup filter must always be in place when operating the hand vacuum.
● Push the dust cup release button and remove the dust cup.
● Verify that the dust cup filter is inside, then reattach the dust cup to the hand vacuum.
● The motorized brush can be used to vacuum short pile carpets or rugs. To attach the
motorized brush, make sure the switch is in the Off position. Then firmly insert the
motorized brush into the air-intake nozzle, ensuring that the contact pins are
engaged in the connector slots of the unit.
WARNING: Do not touch the motorized brush while it is in motion.
● The crevice tool can be used to clean narrow, hard to reach places. The dusting
brush is used for the furniture, venetian blinds, books, lamp shades and shelves.
Attach the desired attachment by pushing it into the air-intake nozzle.
USING THE CORDLESS VACUUM
CAUTION:
The air-intake nozzle and attachments must be free of obstructions at all times,
otherwise the motor will overheat and could become damaged.
● To start the vacuum, push the switch to the “On” position.
● To turn the vacuum “Off”, push the switch to the “Off” position.
CHANGING & CLEANING THE DUST CUP FILTER
NOTE:
It is recommended that the dust cup filter be replaced every 6 - 9 months to ensure
peak performance of the vacuum.
● Press the dust cup release button and pull out the dust cup.
● Carefully remove the dust cup filter and empty the dust from the dust cup.
● Rinse the dust cup filter in cold water and let it dry completely before replacing back
into the dust cup. Do not wash it in a washing machine or use a hair dryer to dry it.
Air dry only!
CHARGING BASE / WALL MOUNTING BRACKET
● If you wish to mount the charging base onto a wall, make sure that the intended wall
area that is to be drilled is free from any hidden electrical wires, water pipes and gas
lines.
● Select an appropriate place that is close to an electrical outlet. Do not mount near
direct sunlight, near a heat source or outdoors.
