Hoover H-WASH 700, Manual

Page: 82 / 156

82
l
The appliance calculates the time
remaining based on a standard load, but
during the cycle the machine may change
it depending on the volume and
composition of the load.
PROGRAMME END
l
After the display shows the cycle has
ended and the
DOOR LOCK light has
switched off, you can open the door.
PAUSING THE MACHINE
l
Press PAUSE to stop the ongoing cycle
for a short time.
l
Press the START button again to resume
the programme from where it left off.
CANCELLING A PRESET CYCLE
l
To cancel the programme, press the
STOP button.
l
Wait for the DOOR LOCK light to turn off
before opening the door.
If you frequently use a programme you
have customised to suit your needs, the
appliance can memorise the settings by
saving it among your favourites, so you can
quickly retrieve it. You can save up to 6
programmes.
- SAVING
l
Select a programme, change the
temperature, spin speed and, if required,
choose other options, then press .
l
After you have memorised it, it will be
saved among your
FAVOURITES in the
home page.
l
Every memorised programme will be
saved in chronological order and
identified by a number from
1 to 6 (from
the oldest to the most recent).
- DELETING
l
To delete one of your favourite
programmes, keep its icon pressed for
approximately
3 seconds and then press
.
The home display screen will always show
the last programme you used, with the
various chosen options, so you can select it
quickly.
l
By selecting the specific icon and swiping
along the ring dial, you can change the
temperature of the wash cycles.
l
If you want a cold wash, all the lights
must be off.
l
By selecting the specific icon and swiping
along the ring dial, you can reduce the
permitted spin speed in the selected
programme, until there is no spin at all.
If the REMOTE CONTROL function is
active, the door will remain locked
(and the light on) until it is
deactivated.
For safety reasons, in some phases of
the wash cycle, the door can only be
opened if the level of the water is
below the door’s lower rim and the
temperature is below 45°C. If these
conditions are met, wait for the DOOR
LOCK icon to switch off before
opening the door.
FAVOURITES menu
Last programme used
Setting the temperature
To avoid damage to fabrics, it is not
possible to increase the temperature
above
the highest temperature
established for each programme.
.
Setting the spin speed