Hoover FloorMate SpinScrub Cleaner, User Manual, Page: 15 / 40

Before storing cleaner:
Turn cleaner OFF and disconnect from electrical outlet.
• Empty and rinse solution and recovery tanks. Allow to air
dry.
• Press on upper handle release button to lower handle for
storage.
• Make sure that nothing is pressing on the nozzle squeegee.
• Do not store cleaner on a wood surface unless cleaner is
completely dry.
For your convenience, the HOOVER® FloorMate™
SpinScrub™ tool caddy (A) is provided for storing the
hose, tool, telescoping wand, set of brushes and detergent.
The caddy conveniently fits over the top of the cleaner nozzle
(B) for storage.
To store hose:
Place the hose grip (C) into slot (D) on
back of caddy. Pull hose up and press into cut-out area
(E). Continue wrapping hose down, underneath tongue
(F), and back up, pressing into second cut-out area (G). Place
hose end (H) into slot (I) on back of caddy.
Place floor swivel tool (J), telescoping wand (K) and
detergent (L) into caddy as shown.
15
Using the tool
Storing the cleaner
Tool caddy
38
39
40
41
The handle must be in the upright position in order
to get cleaning solution through the hose.
✓
Squeeze and hold trigger (A) in hose grip to release
cleaning solution.
✓
Let go of trigger and pull tool over same area to pick
up dirty solution without putting down more solution.
38
39
40
41
A
A
B
NOTE: It may be necessary to remove air from the system
(prime the pump) so the clean solution will flow to the tool.
After attaching the tool to the hose, turn the cleaner ON. Put the
tool against your hand to block off the suction. Wait a few sec-
onds, then squeeze the trigger and begin cleaning.
D
H
I
F
J
K
L
L
G
E
C
Continued
➜