Hoover FloorMATE Floor Mate with Spin Scrub Brushes The Hard Floor Cleaner, Owner'S Manual

Page: 9 / 14

OPERATION BRUSH CONTROL SWITCH WET/DRY PEDAL
Dry Vacuuming “Wet/Dry Pickup” (UP) Dry Pickup
Wet Cleaning “Wet Scrub” (DOWN) Wet Pickup/
Scrub
Wet Pickup “Wet/Dry Pickup” (UP) Wet Pickup/
Scrub
See Page 6 Figs. 2-6 and 2-7 for complete instructions on the control switch
and pedal.
9
3. How to clean
Recommended Cleaning Sequence
Use your HOOVER ‘FloorMate’ Cleaner to:
1.
Dry Vacuum to remove loose dirt, hair and debris.
2. Wet Clean the floor surface. The brushes will provide light agitation to help
loosen dirt.
3. Wet Pickup reduces drying time of the floor surface.
Follow the chart to set the controls for each cleaning step.
To Clean Floor (vinyl, tile,
linoleum, etc.)
1. Set cleaner for Dry Vacuuming
operation and vacuum floor. (See
chart on page 9.)
2. Empty Recovery Tank. (Figs. 2-16
through 2-20).
3. Fill solution tank with Machine For-
mula LYSOL® Floor Cleaning Con-
centrate and water, according to
instructions for Figs. 2-8 through 2-
12.
Do not use pine or solvent
based cleaning concentrates in
your cleaner. Do not use any type
of wax in your cleaner.
4. Set cleaner controls for “Wet
Cleaning” operation. (See chart on
page 9.)
5. Dry hands and plug cleaner into a
properly grounded outlet.
6. Step on handle release pedal and
lower handle to operating position;
turn cleaner ON.
7. To release solution, squeeze trig-
ger (A). Slowly move cleaner forward
and backward over area to be
cleaned. Squeeze trigger to release
solution as needed.
Overlap strokes by one inch to help
prevent streaking.
The cleaner’s suction will pick up the
dirty solution throughout cleaning.
8. To greatly enhance drying of the
floor surface, release trigger and
move wet control switch up to the
“WET/DRY PICKUP” setting. Contin-
ue to move cleaner over the area to
pick up the dirty solution.
9. To continue cleaning another area,
move wet control switch down to
“WET Scrub”. Repeat with steps 7-9.
NOTE: When switching between wet
cleaning and wet pickup, it is not nec-
essary to turn the cleaner off. Simply
move the control switch back and
forth between the two settings.
10. Empty recovery tank or clean the
filter when the motor sound becomes
higher in pitch and there is a loss of
suction (see “Automatic Shut-Off”,
page 7).
3-1
A