Tank Status Indicators
The computerized controls will perform a self diag-
notics test the first time the machine is powered
up after being plugged in. This process takes 5
seconds during which all of the lights on the control
panel will flash. This is normal.
The appropriate tank status light will blink when
the Clean Water or Detergent Tank is empty.
In some circumstances, “soft water” or certain
3.7
Emptying the Dirty Water Recovery Tank
3.8
Lower cleaner han-
dle to the floor.
3.9
Grasp handle of
Dirty Water Recovery
Tank and pull straight
up.
3.10
Set tank on coun-
ter-top or table and
remove lid by pushing
button (A) and pivoting
the lid up and away
from tank.
3.11
Dump dirty water
in sink or toilet. Rinse
out Dirty Recovery Tank
and be sure to remove lint
and dirt from screen (B).
detergents might not be recognized by the sen-
sor. The cleaner will continue to operate properly
even though the light has been activated.
The tank status light representing the Dirty
Water Recovery Tank will blink when the tank is
full and needs to be emptied. In this state, the
cleaner will no longer dispense liquid so that the
carpet does not become over-saturated.
3.12
Secure lid to tank
and place tank back
into cleaner.
HOW
TO
OPERATE
3. HOW TO OPERATE
12
3.12
A
B
Turn carpet cleaner off and unplug from outlet. Do not use without float in place. If broken or dislodged, take
to an authorized Hoover
®
dealer for repair.
3.9
3.10
3.8
3.11
