Hoover Dynamic Next WDMT413AI2, Manual

Page: 17 / 32

EN
17
The display’s indicator system allows you to
be constantly informed about the status of
the machine.
2
13 14
1 6 15 10 12 5
7 7 7 7 7
8 9 4 11
3
16
1) DOOR LOCKED INDICATOR LIGHT
l
The indicator light is illuminated when the
door is fully closed.
l
When START/PAUSE is pressed on
the machine with the door closed, the
indicator will flash momentarily and then
illuminate.
l
A special safety device prevents the door
from being opened immediately after the
end of the cycle. Wait for
2 minutes after
the wash cycle has finished and the
DOOR LOCKED light has gone out
before opening the door. At the end of the
cycle press the
ON/OFF button (for at
least 3 seconds ).
2) SPIN SPEED
This show the spin speed of the selected
programme that can be changed or omitted
by the relevant button.
spin speed cancelled.
3) WASH TEMPERATURE
This show the washing temperature of the
selected programme that can be changed
(where allowed) by the relevant button.
cold wash.
4) CYCLE DURATION
l
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
l
Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the wash.
l
The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.
l
If automatic washing/drying is selected, at
the end of the wash phase, the drying time
remaining to the end will be shown on the
display.
5) WASH TIME
l
Once the programme has been selected,
the indicator light will automatically show
the wash time set for that programme.
l
Selecting a different wash time the
relevant indicator will light up.
Digital Display
Close the door BEFORE selecting the
START/PAUSE button.
If the door is not properly closed,
the light will continue to flash for
about 7 seconds, after which the
start command will be automatically
delete. In this case, close the door
in the proper way and press the
START/PAUSE button.