1.Picures shown on the package may be slightly different from the actual product.
2.All the materials are taken in the operation step, put the remaining materials back into the original pocket until the installation is completed.(Avoid material loss during installation
)
3.The dimensions indicated in the step diagram are
“
cm”.
4.If there have template paper material, please cut the material according to the template to avoid mistakes..
5.According to the part rule example at the bottom of this page
,
refer to the part on the part number drawing, find the material object and compare with the material list, confirm and
install.(Wooden parts only)
6.Glue should not be applied too much, so as not to dry longer, overflow will affect the effect of the finished product
.
7
..
Part shapes may differ from the photographs depending on he production batch
Tips for assembling
Be sure to test the LED lights before making the lighting,
note that the LED white wire to the negative, gray wire
to the positive reference to the following figure
operation test.
Testing on LED function
DO NOT contact the
LED wire end direct
to the battery cell.
Use the provide battery
holder. Make sue the
correct polarity.
How to assemble the battery holder
1.Material and tools needed:
- Battery holder, LED bulb,
tape, screw driver and 2 piece
AAA size battery(not provided)
2. Use screw driver and
take the lid off from the
battery holder.
3. Insert the battery take
notes on the polarity.
4. Connect the red wire
to grey wire. Connect
the black wire to white
wire.
5.Wrap the exposed wire
with the tapes.
6. Place the box lid and
fastness with screw driver.
A01:The parts are directly in the box: B01: The parts are in the B bag; C01: The parts are in the C bag, and so on (Note: The printing paper is displayed
in the step A28-01: The printing paper is placed directly in the box , The part number is A28-01)
Note: Materials A23, A24, A25 and A26 are placed in the material bag A.
Examples of parts rule:
Tips for Assembling Wood
Find the corresponding block number,
use a knife in the connection point
gently press, you can take out the wood.
Use a knife to smooth out the burr
Or use sandpaper to smooth
out the burr
