23
2. Insert the prepared noise detector connection cable into the corresponding input wiring
terminal (8P) and tighten the screws.
3. Insert the wiring terminal of the installed cable into the DCS supervision port.
4. Connect the Speaker Line of noise detector to the area.
5. Fix the noise detector and if there are many detectors in a same line, please follow the
connection method shown in Figure 21.
6. Choose a fix method based on the surrounding situation. It can be embedded in ceiling or
install it though hanging.
7. If the appearance of noise detector is similar to the end-of-line supervision module, installation
can be conducted according to corresponding method.
Figure 21 Schematic Diagram of the X-DCS3000 Connection to the Noise Detector
Connecting Module X-EOL
End of line supervision modules and noise detectors may be installed on the same line- see the
following steps:
0. Open the cover, set module address 1 to 5 according to binary code and switch address 1 to
ON position, which is shown as below.
Summary of Contents for X-618
