46
Vuquest 3320g User Guide
Deactivation Character
This sets the character used to terminate scanning when using Character Deacti-
vation Mode. On the
ASCII Conversion Chart (Code Page 1252)
, page 212, find the
hex value that represents the character you want to use to terminate scanning.
Scan the following bar code, then use the
to read the alphanu-
meric combination that represents that ASCII character. Scan
to finish.
Reread Delay
This sets the time period before the scanner can read the
same
bar code a second
time. Setting a reread delay protects against accidental rereads of the same bar
code. Longer delays are effective in minimizing accidental rereads. Use shorter
delays in applications where repetitive bar code scanning is required. Reread
Delay only works when in a
Default = Medium.
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below,
then set the delay (from 0-65,535 milliseconds) by scanning digits from the inside
back cover, then scanning Save.
Deactivation Character
Short (500 ms)
* Medium (750 ms)
Long (1000 ms)
Extra Long (2000 ms)
User-Specified Reread Delay
Summary of Contents for Vuquest 3330
