Honeywell UltraKey Lite HJC5000, Installation And User Manual

Page: 33 / 72

UltraKey Lite Controller Installation and User Guide
Document 800-07422 Rev A 33
08/10
Note For a list of accessories see Shipping Checklist on page 18 and for port
connections see UltraKey Lite Port Connections and Descriptions on page 19 .
1. Select the applicable adapter plug and insert it into the AC adapter. Push to click it
into place. See
Figure 3-3 .
2. Plug the AC adapter into the controller power port and the adapter into a power
source.
3. Connect an RJ45 network cable to the controller serial port.
4. Connect the RJ45 network cable to VideoBloX:
• For backwards compatibility with VideoBloX and VideoBloX Lite CPUs, an RJ45
to DB9 male adapter is required and included with your shipment. See
Figure 3-4 .
• For VideoBloX NetCPU, the installation is a direct connection with the RJ45
network cable, also included. See
Figure 3-5 and Figure 3-6 .
Figure 3-3 AC Power Adapter with CEE 7/16 Europlug
Table 3-1 Serial Port COM1 and COM2 Pin Assignments
Serial Port Type Pin Signal
COM1 RS422 1 RX +
2 RX –
5 GND
7 TX –
8 TX +
RS485 7 T/R –
8 T/R +
Slide plug onto the
adapter and snap
into place