Honeywell UDC3200 series, Product Manual

Page: 129 / 243

Monitoring and Operating the Controller
Set up Procedure
The following procedure (Table 4-17) to:
•
select two sets,
•
set the switch-over value,
•
set tuning constant value for each set.
Table 4-17 Set Up Procedure
Step Operation Press Result
1 Select Control
Set-up Group
Setup Setup
Until you see:
Upper Display = SET
Lower Display = CONTRL
2
Select PID SETS
Function Function Function
Until you see:
Upper Display = (available selections)
Lower Display = PID SETS
3 Select PID SETS
Function
or To select the type of function. Available selections are:
1 ONLY— 1 set of constants
2KEYBD —2 sets, keyboard selectable
2PV SW —2 sets, auto switch at PV value
2SP SW —2 sets, auto switch at SP value
4 Set Tuning
Values for Each
Set
Refer to “TUNING” Set up group, subsection 3.4 and set the
following tuning parameters:
PB or GAIN *
RATE MIN *
RSET MIN or RSET RPM *
CYC SEC or CYC SX3 *
PB2 or GAIN2 **
RATE2MIN **
RSET2MIN or RSET2RPM **
CYC2SEC or CYC2SX3 **
*PIDSET1 will be used when PV or SP, whichever is
selected, is
greater than the switchover value.
**PIDSET2 will be used when PV or SP, whichever is
selected, is
less than the switchover value.
5
Set Switchover
Value for
2 PVSW or
2 SPSW
Selection
Function Function Function
Until you see:
Upper Display = (the switchover value)
Lower Display = SW VAL
or
To select the switchover value in the upper display.
12/04 UDC3200 Universal Digital Controller Product Manual 117