69-0927—4
4
T8511G,R MICROELECTRONIC HEAT PUMP THERMOSTATS
Fig. 10. T8511G (automatic changeover) system
and fan keys location.
NOTE:
Always press the system and fan keys with your
fingertip or similar blunt tool. Sharp instruments
like a pen or pencil point can damage the
keyboard.
Temperature Settings
The default setpoint for heat is 70
°
F (21
°
C) and for cool is
78
°
F (25.5
°
C). Press the increase
▲
or decrease
▼
key to
change the present setting. To change between heat and
cool, press the Information
i
key until the setting to be
changed appears.
Fig. 7. Mounting thermostat on wallplate.
NOTE:
To remove the thermostat from the wall, first
pull out at the bottom of the thermostat; remove
top last.
Using Thermostat Keys
The thermostat keys are used to:
•
set temperature,
•
display present setting,
•
configure Installer Setup,
•
check System-Test,
•
display outdoor temperature (select models).
The T8511G has keys to:
•
set the system operation,
•
set the fan operation.
See Fig. 8 for the key information.
M6798A
B.
PRESS LOWER EDGE OF CASE TO LATCH.
A.
ENGAGE TABS AT TOP OF THERMOSTAT AND WALLPLATE.
Fig. 8. Thermostat key locations and descriptions.
SETTINGS
System and Fan Settings
System settings control the thermostat operation as
follows:
Em. Heat: Emergency heat relay is automatically
controlled by the thermostat. The cooling system is
off. The compressor is de-energized.
Heat: The thermostat controls the heating.
Off: Both the heating and cooling are off.
Cool: The thermostat controls the cooling.
Auto: The thermostat automatically changes between
heating and cooling operation, depending on the
indoor temperature.
Fan settings control the system fan as follows:
On: Fan operates continuously.
Auto: Equipment controls fan.
The system default setting is Heat and the fan default
setting is Auto. Use the keyboard or system and fan
switches, depending on model, to change to the desired
settings. See Figs. 9 and 10.
Fig. 9. T8511R (manual changeover) system
and fan switches location.
M10147
i
Press to select
heating or cooling
equipment.
Em. Ht.-Emergency heating
Heat— Heating equipment
Off — No equipment
Cool—Cooling equipment
Auto—Thermostat
automatically selects
heating and cooling
equipment.
Press to select
heating or cooling
equipment.
On—
Fan runs continuously
Auto—Fan runs when
heating or cooling
equipment operates
System
System
System
Fan
Fan
Fan
1
1
CHECK LIGHT ON SELECT MODELS
M6801
DISPLAY PRESENT
SETTINGS AND SCROLL
THROUGH INSTALLER
SETUP MODES
(INFORMATION KEY)
i
DECREASE
TEMPERATURE
SETTING
INCREASE
TEMPERATURE
SETTING
M11037
i
EM. HEAT HEAT OFF COOL
ON AUTO
EM. HEAT HEAT OFF COOL
ON AUTO
SYSTEM
Selection for heating or cooling
equipment operation.
Heat - Heating equipment
Off - No equipment
Cool - Cooling equipment
FAN
On - Fan runs continuously
Auto - Fan runs when
heating or cooling
equipment operates
