Honeywell Thor VM3, User Manual, Page: 193 / 378

Thor VM3 with Microsoft Windows Embedded Compact 7 User Guide 181
Network and Dialup Connections
Start > Settings > Control Panel > Network and Dialup Connections
Set Thor VM3 network driver properties and network access properties. Select a con-
nection to use, or create a new connection.
Create a New Connection
1. On the mobile device, select Start > Settings > Control Panel > Network and Dialup
Connections. A window is displayed showing the existing connections.
2. Assuming the connection you want does not exist, double-tap Make New
Connection.
3. Give the new connection an appropriate name (My Connection @ 9600, etc.). Tap the
Direct Connection radio button. Tap the Next button.
4. From the popup menu, choose the port you want to connect to. Only the available
ports are shown.
5. Tap the Configure... button.
6. Under the Port Settings tab, choose the appropriate baud rate. Data bits, parity, and
stop bits remain at 8, none, and 1, respectively.
7. Under the Call Options tab, be sure to turn off Wait for dial tone, since a direct
connection will not have a dial tone. Set the timeout parameter (default is 5
seconds). Tap OK.
8. TCP/IP Settings should not need to change from defaults. Tap the Finish button to
create the new connection.
9. Close the Remote Networking window.
10. To activate the new connection select Start > Settings > Control Panel > PC
Connection and tap the Change Connection… button.
11. Select the new connection. Tap OK twice.
12. Close the Control Panel window.
13. Connect the desktop PC to the mobile device with the appropriate cable.
14. Click the desktop Connect icon to test the new connection.