80
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
•
Ignition Control Wiring Diagram
•
Auto-On Control Wiring Diagram
•
5. Route the power cable the shortest way possible removing any left-over cable. The
6. Provide mechanical support for the cable by securing it to the vehicle structure at
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate outer cable jacket.
7. Connect the watertight connector end of the power cable to the Thor VM2 dock
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely.
8. Secure the power cable to the Thor VM2 using the
.
9.
10. If using the
feature, install the screen blanking box or switch.
11. Press the
on the back of the Thor VM2 dock.
12. Press the
on the front of the Thor VM2 to turn on the Thor VM2.
Once installation is complete, remember to start the Thor VM2 and select the desired
Power Configuration Mode to enable Auto-On, Ignition Control or Manual Control of the
Thor VM2 boot up process.
control panel.
Ignition Control Wiring Diagram
Ignition wire must be connected and the Ignition Control power mode must be selected
via the
control panel. When switched vehicle power is avail-
able the Thor VM2 ignition signal wire can be connected (less than 1mA over input volt-
age range) to the switched circuit to allow the Thor VM2 to power on when the vehicle is
switched on. When the vehicle is switched off, more aggressive power management set-
tings are enabled to preserve the vehicle battery charge.
Summary of Contents for Thor VM2
