Honeywell Thor VM2, User Manual, Page: 194 / 398

182 Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Next, create a Bluetooth address bar code label for the Thor VM2.
The format for the bar code label is as follows:
• Bar code type must be Code 128.
• FNC3 character followed by string Uppercase L, lowercase n, lowercase k, uppercase
B and then the Bluetooth address (12 hex digits, no colons). For example,
LnkB0400fd002031.
Create and print the label.
Scan the Thor VM2 Bluetooth address bar code label with the Bluetooth bar code
reader.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps
and LED flashes.
Note: After scanning the Thor VM2 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth bar code reader, the devices are currently paired.
See Bluetooth Beep and LED Indications .
Bluetooth Beep and LED Indications
Beep Type from Bluetooth Device Behavior
Acknowledge label 1 beep
Label rejected 2 beeps at low frequency
Transmission error Beep will sound high-low-high-low
Link successful Beep will sound low-medium-high
Link unsuccessful Beep will sound high-low-high-low
LED on Bluetooth Device Behavior
Yellow LED blinks at 2 Hz Linking in progress
Off Disconnected or unlinked
Yellow LED blinks at 50 Hz Bluetooth transmission in progress
Yellow LED blinks at the same rate as the paging beep (1
Hz) Paging