Honeywell THOR VM1, Reference Manual, Page: 131 / 324

Bluetooth Bar Code Reader Setup
Please refer to the Bluetooth scanner manufacturer’s User Guide; it may be available on the manufacturer’s web site. Contact
your
representative for Bluetooth product assistance.
Several different types of bar code readers are supported. This section describes the interaction and setup for a mobile
Bluetooth laser scanner or laser imager connected to the Thor VM1 using Bluetooth functions.
Prerequisites
l
The Thor VM1 has the Bluetooth hardware and software installed. An operating system upgrade may be required.
Contact your
representative for details.
l
If the Thor VM1 has a Bluetooth address identifier bar code label affixed, then Bluetooth hardware and software is
installed.
l
The mobile Bluetooth laser scanner / laser imager battery is fully charged.
l
The Thor VM1 is connected to AC or DC (vehicle) power.
l
Important : The bar code numbering examples in this segment are not real and should not be created nor scanned with a
Bluetooth scanner.
l
To open the LXEZ Pairing program, tap Start > Settings > Control Panel > Bluetooth or tap the Bluetooth icon on the
desktop or tap the Bluetooth icon in the taskbar.
Locate the bar code label, similar to the one shown above, attached to the Thor VM1. The label is the Bluetooth address
identifier for the Thor VM1.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing, connecting or disconnecting can
occur.
Important : The Thor VM1 Bluetooth address identifier label should remain protected from damage (rips, tears, spills, soiling,
erasure, etc.) at all times. It may be required when pairing, connecting, and disconnecting new Bluetooth bar code readers.
Thor VM1 with Label
If the Thor VM1 has a Bluetooth address bar code label attached, follow these steps:
1. Scan the Bluetooth address bar code label, attached to the Thor VM1, with the Bluetooth mobile scanner.
2. If this is the first time the Bluetooth scanner has scanned the Thor VM1 Bluetooth label, the devices are paired. See
section titled “ Bluetooth Beep and LED Indications ”. If the devices do not pair successfully, go to the next step.
3. Open the LXEZ Pairing panel (Start > Settings > Control Panel > Bluetooth).
4. Tap Discover. Locate the Bluetooth scanner in the Discovery panel.
5. Double-tap the stylus on the Bluetooth scanner. The right-mouse-click menu appears.
6. Select Pair as Scanner to pair the Thor VM1 with the Bluetooth mobile scanner.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps and an LED flashes. Refer to the
following section titled “
Bluetooth Beep and LED Indications ”.
Note: After scanning the Thor VM1 Bluetooth label, if there is no beep and no LED flash from the Bluetooth
device, the devices are currently paired.
3-69