14
13
Note: When the temperature falls below freezing, the
batteries in outdoor remote sensor(s) may have reduced
voltage supply and a shorter effective range. We recommend to
Use lithium-ion batteries at the temperatures below 32
°
F
If everything listed above is in order and there is no reception
anyway, please perform the following steps:
1. Bring main unit and remote sensor close together.
2. Remove 4 small screws from the back of the remote sensor
and open the battery compartment.
3. Remove the batteries from the battery compartment and
reinstall them in the same manner. Remote sensor
LED indicator will flash showing transmission of the signal.
4. Remove the batteries from the main unit and reinstall
them in the same manner.
5. On the main unit select the same channel number as
set on the remote sensor. Outdoor temperature
on the display will show that transmission is being
received successfully .
TRANSMISSION COLLISION
Signals from other household devices, such as doorbells,
home security systems, and entry controls, may interfere
with this product and may cause temporary reception
failure. This is normal and will not affect the general
performance of the product. The transmission and reception
of temperature readings will resume once the interference
subsides.
SEA LEVEL ADJUSTMENT
To enter
SEA LEVEL
in feet or meters:
1) Press and hold
UNIT
button – pressure display unit will flash.
2) Press
UP
or
DOWN
button to select
FEET
or
METER
.
3) Press
UNIT
again to confirm the setting.
To enter sea level:
1) Press and hold
PRESSURE/ALTITUDE
button for
2-3 seconds
2) Press
UP
button to increase sea level.
3) Press
DOWN
button to decrease sea level.
If none of these buttons pressed during 5 second period,
display will return to the original display and the last altitude
setting will be stored in memory automatically.
NOTE: All of the historical pressure data will be cleared once
an altitude has changed.
TEMPERATURE AND HUMIDITY SCANNING
Press and hold
CHANNEL
button for 2 seconds – the indoor,
channel 1, 2 and 3 readings will be displayed in sequence
automatically.
MOON PHASE INDICATOR
Displayed in accordance with the calendar
LOST COMMUNICATION
If the main unit display for the remote sensor goes blank,
press and hold [ ] button for 2 seconds to begin a new
signal search. If the signal still isn’t received,
please make sure that:
1. The remote sensor is in the proper location.
2. The distance between the main and remote units is not
over 100 feet,
3. The path between units is clear of obstacles. Shorten the
distance between units if necessary.
4. Fresh batteries are installed correctly in both remote sensor
and main units.
ATOMIC CLOCK
1. After the main unit receives temperature and humidity
readings from the remote sensor(s), the WWVB time signal
receiver will automatically search for the time signal. This
takes about 5-8 minutes. Always place the main unit by the
window for better reception.
2. If the radio signal is received, the date and time will be
set automatically, and the [ ] icon will appear.
3. If after 8 minutes the time signal has not been received,
press the “
MODE
” button to set the time manually.
The clock will continue to search for the WWVB time
signal daily from 1:00 am to 4:30 am.
When the signal has been successfully received, the time
and date will be updated automatically.
New
Moon
Waning
Crescent
Waning
Crescent
First
Quarter
Waxing
Gibbous
Full
Moon
Waning
Gibbous
Last
Quarter