Honeywell T8602D, Installation Instructions Manual

Page: 6 / 12

T8602D CHRONOTHERM
®
IV DELUXE PROGRAMMABLE THERMOSTATS
69-1507—2 6
Table 3. Thermostat Installer Setup Options.
Select
Installer Setup
Number (Press
Time
∆
key to
change)
Factory Setting
Other Choices
(Press or key to change)
Actual
Setting Display Description Display Description
Not Used. 1 — — — — —
Fan operation
a 2 0 Conventional
applications where
equipment controls
fan operation in
heat mode 1 Heat pump or electric heat
applications where
thermostat controls fan
operation in heat mode.
Not Used. 3 — — — — —
Heating cycle
rate. 4 6 6—6 cph used for
conventional heat 1, 3 or 9 1—1 cph used for radiant
floor heat, gravity system
3—3 cph used for hot water
systems or high
efficiency furnaces
9—9 cph used for electric
heat systems
Not Used. 5 thru 11 — — — — —
System setting
adjustment 12 1 Manual
changeover 0 or 2 0—Auto changeover
2—Auto only
Adaptive
Intelligent
Recovery™
control. 13 0 Adaptive Intelligent
Recovery™
control is activated
(system starts
early so setpoint is
reached by start of
program period). 1 Conventional recovery
(system starts recovery at
programmed time). —
Degree
temperature
display 14 0 Temperature is
displayed in °F 1 Temperature is displayed
in °C
Not Used. 15 — — — — —
Clock format. 16 0 12-hour clock
format. 1 24-hour clock format.
Not Used. 17 and 18 — — — — —
Extended fan
operation in
heating.
a
19 0 No extended fan
operation after the
call for heat ends. 1 Fan operation is extended
90 seconds after the call for
heat ends.
Extended fan
operation in
cooling.
a
20 No extended fan
operation after the
call for cool ends. 1 Fan operation is extended
90 seconds after the call for
cool ends.
Not Used. 21 thru 23 — — — — —
Outdoor
temperature
display (models
with OT
terminals). 24 0 No outdoor
temperature is
displayed. 1 Outdoor temperature is
displayed. Needs a
C7089B1000 Outdoor
Temperature Sensor to
operate.
Not Used. 25 thru 29 — — — — —
Deadband 30 3 Heating and
cooling setpoints
can be set no
closer than 3°F
(1.5°C). 4 thru 10 Heating and cooling
setpoints can be set no
closer than the chosen
value:
4—4°F (2°C)
5—5°F (2.5°C)
6—6°F (3°C)
7—7°F (3.5°C)
8—8°F (4°C)
9—9°F (4.5°C)
10—10°F (5°C)
Not Used. 31 thru 32 — — — — —