3 Place Back cover over junction box, insert and
tighten mounting screws.
4 Insert the cable into connector on circuit board of
thermostat.
5 Align 4 tabs on the Back cover with corresponding
slots on the back of the thermostat, and then push
it until the thermostat snaps in place.
Installer Set-Up (ISU) setting
Press and
simultaneously for 3 seconds to
enter ISU as below:
Number
Setting
Press or to change settings
Press
to advance to next function
Press and hold
and buttons 3 seconds to
exit and save settings
Installer system test
After completing the installer setup above, press the
button again to begin a system test
Follow the procedure below to test the heating and
cooling and fan system.
System
System test No.
Press and hold and buttons 3 seconds to enter
test mode.
Press or button to change system status.
Press button to advance to next test number.
Press and button hold to terminate system test
at any time.
System Test System Status
10 Heat 0 Heat turn off.
1 Heat turns on.
30 Cool 0 Cool off.
1 Cool on.
40 Fan 0 Fan off
1 Low speed Fan on
2 Medium speed Fan on
3 High speed Fan on
70 Thermostat information(for reference only)
71 Software revision number (major)
72 Software revision number (minor)
73 Configuration identification code (major)
74 Configuration identification code (minor)
75 Production configuration date code (week)
76 Production configuration date code (year)
APH07CH04
-
R2001EN
