Honeywell SmartLine ST700, Quick Start Installation Manual

Page: 21 / 24

SmartLine Pressure Transmitter
December 2016 Quick Start Installation Guide 21
Table 6
– Advanced Display Configuration (ST 800 only)
ST 800 Only
<Return> <Return>
Critical Active Diags
Non-Critical <Return> Meterbody
Active Diags Elec Module
Analog Out mode Meterbody Comm
Zero Correct
Span Correct
Supply Voltage
Primary PV
Meterbody Temp
Elec Module Temp
Meterbody Comm
Factory Cal
DAC Temp Comp
<Return>
<Return>
<Return> Set contrast Screen Format
LCD Contrast Trend Duration
Common Setup <Return> PV Selection
Screen 1 Language PV Scaling
Screen 2 Rotation Time Display Units
Display Setup
Screen 3 Custom Units
Screen 4 Decimals
Screen 5 Disp Low Lim
Screen 6 Disp High Lim
Screen 7 Scaling Low
Screen 8 Scaling High
Custom Tag
<Return>
Hour
Minute
Year
Month
<Return> Day
Set Time Stamp
Zero Correct <Return> <Return>
LRV Correct Do ( ) Correct Trim Zero
URV Correct Trim Span
Reset Corrects <Return> Set DAC Normal
DAC Trim Set DAC Output
Loop Test Set DAC Normal <Return>
<Return> Tag ID
Parameters Units
Transmtr Setup
Enter LRV <Return> Damping (sec)
Enter URV Enter (LRV/URV) NAMUR Selection
Set LRV <Return> Filter Perf.
Set URV Set (LRV/URV) Transfer Func.
Install Date Flow Cutoff
<Return> <Return> Breakpt (%Flow)
Display Firmware Version
Information
Elec Module <Return> <Return>
Meterbody Firmware Version Firmware Version
HART/DE Version Model Key
Protocol Units
LRL
URL
Calibration
Diagnostics