2
1
3
Figure 3: Installation of rear module only, method one
Step 1: Insert the bottom of the IDP-Relay-6 module
down into a rear slot on the chassis.
Step 2: Carefully swing the upper edge of the board
back towards the back of the chassis until it
touches the two standoffs.
Step 3: Align two 4-40 screws with the two standoffs
and tighten.
Step 4: Address and wire the modules according to the
instructions in this manual.
The steps in Figures 4a and 4b describe and illustrate mod-
ule installation when the rear chassis position and the posi-
tion in front of it will be filled. Front position installation
is possible only if the rear position is filled with a module.
1
Figure 4a: Installation of IDP-Relay-6 module in a
rear chassis position, method two
Step 1: Insert the bottom edge of the IDP-Relay-6
module down into a rear slot of the chassis.
Step 2: Carefully swing the bottom edge of the board
towards the back of the board until it touches the
short standoff attached to the chassis.
Step 3: Align the long standoff with the short standoff
and tighten.
COMPONENTS
The following is a description of the IDP-Relay-6 mount-
ing framework:
• One or two IDP-Relay-6 modules can be installed in a
IDP-ACB cabinet
The IDP-ACB cabinet has a built-in chassis that will ac-
commodate one or two IDP-Relay-6 modules.
0
1
2 3 4 5 6
7
8
9
0
7
8
6
5
4
3
2
1
9
1
0
11
1
2
1
3
1
4
1
5
BASE
ADDRESS
ADDRESS
DISABLE
N
O
N
E
O
N
E
TW
O
TH
R
E
E
0
1
2 3 4 5 6
7
8
9
0
7
8
6
5
4
3
2
1
9
BASE
ADDRESS
ADDRESS
DISABLE
NONE
ONE
TW
O
THREE
Figure 1: IDP-ACB Cabinet
The front IDP-Relay-6 module positions of each chassis
are offset below the rear IDP-Relay-6 module positions
so that all of the status indicators are visible. For cabinet
dimensions refer to IDP-ACB instruction manual.
INSTALLATION STEPS
1. Cabinet Mounting
In a clean, dry area, mount the backbox using the four
holes provided in the back surface of the cabinet.
Backbox
Mounting
Holes
Figure 2: Typical mounting hole locations
2. Module Installation
There are two methods for installing a module in the
rear position of a chassis. Method one is for installa-
tion of a rear module only, when no module will be in-
stalled in front of it. Refer to Figure 3 for instructions.
Method two is for installation of a rear module when
another module will be installed in the chassis position
in front of it. Refer to Figures 4a and 4b for method
two. All necessary screws and standoffs are supplied
with the modules.
K200-15-00
2
I56-2732-003
C0235-00
C0234-03
C0249-00
C0244-00