Honeywell SF61, User Manual

Page: 49 / 106

Chapter 2 — Connect the SF61B
SF61 Cordless Scanner User’s Guide 37
To Disconnect from the Host
Use the Bluetooth disconnect procedure specific to your host
application.
When the scanner disconnects from the host, it emits a “disconnect
successful” beep sequence (series of beeps from high to low), and the
blue Intermec Ready-to-Work indicator turns off (default scanner
behavior).
SPP Incoming Connection (Scanner Initiated)
A scanner-initiated (Incoming) SPP connection requires reading a
Bluetooth association bar code then opening the Incoming port from
the host application (a terminal emulation program for example).
The advantage of this method is that the scanner automatically tries
to reconnect to the host application each time the connection is lost.
This method is recommended when you are collecting data for a data
management application.
To connect in SPP device profile—incoming connection
1 Before trying to connect your scanner, make sure that:
• it is not already trying to establish a Bluetooth connection with
another host (blinking blue Intermec Ready-to-Work
indicator), in this case read the
Bluetooth Device Disconnect
bar code:
Bluetooth Device Disconnect
• it is not already paired with your Bluetooth device using
another profile, in this case remove it from your host’s list of
Bluetooth devices
• your host is equipped for Bluetooth communication
2 Scan the SPP Bluetooth device profile configuration code:
Bluetooth device profile - SPP (*)
3 make sure that your host PC is enabled for Bluetooth connection
from an external device (your SF61B).