Honeywell SC500, Manual

Page: 10 / 150

page 10 008-0671-00
Chapter 4, “Chassis Models”, provides information relating to the hardware chassis
such as panel and rack mounting.
Chapter 5, “Options Connector”, contains information about wiring to the 12-pin
Options connector to access the Relay Outputs and serial communications.
Chapter 6, “System Menu”, discusses the System Menu which allows you to exam-
ine and change settings that affect the operation of the chassis.
Chapter 7, “Serial Communications”, briefly describes RS-232 and RS-485 com-
munications. It also shows how to use the
SERIAL COM
Menu to examine the settings
and test the RS-232 or RS-485 communications.
Chapter 8, “Display Menu”, describes the Display Menu which allows you to change
what is shown on the lower line of the instrument’s display.
Chapter 9, “Limits”, discusses how the Limits operate and describes how to alter
their settings via the Limit Menus.
Chapter 10, “Strain-Gage Input Channel”, explains how to wire, configure, operate
and calibrate the Strain-Gage Input Channel with your transducer.
Chapter 11, “AC/AC-LVDT Input Channel”, explains how to wire, configure, operate
and calibrate the AC/AC-LVDT Input Channel with your transducer.
Chapter 12, “High-Level Input Channel”, explains how to wire, configure, operate
and calibrate the High-Level Input Channel with your amplified transducer, in-line
amplifier, or DC-DC LVDT.
Chapter 13, “Split Display Virtual Channel”, shows how you can display two values
from any of the channels in the instrument at the same time.
Chapter 14, “Mathematics Virtual Channel”, describes the flexibility of customer-
specific SensoCode programming.
Chapter 15, “Error Messages”, lists error messages that the instrument may display,
describes their causes and, where possible, suggests solutions.
Chapter 16, “Setup Menu Reference”, is a list of all SETUP menus and a cross-ref-
erence to related information in this instruction manual.