Honeywell Rapid Eye, Installation Manual

Page: 25 / 82

Rapid Eye™ Multi-Media DVR Installation Guide
Document 800-02607V3 Rev A 25
11/09
4. For network connections, assign a TCP/IP Address to the DVR using:
• The LocalView interface
• A Mouse (included)
• A Monitor (not included)
5. Field-test the connection to the DVR.
Field technicians tasked with the initial steps of an installation will find these steps
expanded and explained in more detail in
Connecting Cameras , page 20 , and
Communications , page 20 .
Recording the Installation Details
As you start connecting hardware to the Multi-Media DVR, Honeywell recommends that you
make a record of system information (such as IP address) with the site information checklist
(provided in
Appendix C ). Include a record of the hardware connected to the DVR and
changes to the Rapid Eye site configuration using LocalView.
Rear Panel Connections
Figure 2-1 shows the rear panel connections and Table 2-2 describes the connections.
Figure 2-1 Rear Panel Connectors
Video inputs and outputs, for cameras
Switching outputs,
for video monitors
Serial ports 1~8 Alarm and control
connectors Communication ports