Honeywell Rapid Eye, Administrator'S Manual

Page: 106 / 294

106
Pan, Tilt, and Zoom (PTZ) Setup
2. Do one of the following:
• For mimic tours, select Tour.
• For preset tours, select Vector.
3. Click a button in the row of numbered buttons above the drop-down list.
RapidDome Mimic Tour
1. While using View, select a site that has one or more RapidDome PTZ cameras.
2. Run a Maintenance Session ; click the Video tab.
3. Select a dome camera.
4. Click PTZ. Check if the Driver is RapidDome/Orbiter. If not, this procedure cannot be
used. In the Tour Programming section, Mimic Tour is selected by default. See
Figure 6-11 . You have the option of selecting which of the four mimic tours you plan to
setup. To do so, click the drop-down arrow above the End button. A list appears,
showing Tour 1, Tour 2, Tour 3, and so on, by default. Select an item in the list.
5. Click Program. The message
Tour Programming in progress …
appears below
the buttons in the Tour Programming section (see Figure 6-11 .)
6. Pan, tilt and zoom the camera, as needed.
7. Click End.
8. After the tour is programmed, you can:
• Click Test to test the mimic tour.
• Rename the mimic tour. Click inside the box in the Tour Programming section.
Enter a name. Save the name by clicking the mouse outside of the box.
9. You have the option of programming another mimic tour for the dome camera; repeat
step 5 to step 7 , as needed.
Testing a Mimic Tour on a RapidDome Camera
1. While using View, select the site at which you have programmed a mimic tour on a
RapidDome camera, as shown in
RapidDome Mimic Tour , page 106 .
2. Run a Maintenance Session . On the Video tab, select the dome camera that is
programmed with a mimic tour.
3. Click PTZ. Check if the Driver is RapidDome/Orbiter. If not, the wrong camera or site
may have been selected and this procedure cannot be used.
4. In the Tour Programming section, select a mimic tour, using the drop-down arrow
above the End button. By default, they are named Tour 1, Tour 2, Tour 3, and so on.
5. Click Test.