The cycling pattern of the R841 is determined by the
frequency, the R841 switch contacts make
thermostat(s). On a call for heat, the thermostat(s)
mately 75 seconds (from cold start) after the thermostat
activates the low voltage resistance heater(s) in the
calls for heat. (The top switch on the special R841 E
The heater(s) drives the
strip(s) to actuate
with optional specification is adjusted to approximately
the
MICRO SWITCH snap-acting switch or switches.
55 seconds; the bottom switch to approximately 75
The
strip is ambient temperature compensated
seconds. This allows, at the very minimum, 10 seconds
within the specified ambient range. At rated voltage and
between stages in both make and break sequence.)
After mounting and wiring have been completed, turn
heating equipment functions properly. Return the
on the power supply. Set the thermostat above room
mostat to the desired room temperature before leaving
perature until the electric heating equipment starts.
the installation.
Permit the system to operate long enough to prove the
Dear Customer,
Please send your
and suggestions to:
We welcome your comments and suggestions for improving this
Inc.
cation. Your assistance is greatly appreciated and will
us to provide
Honeywell Plaza
better
information for ye”.
Minneapolis, Minnesota 55408
ATTN: Publications Supervisor MN 12-3247
H O N E Y W E L L
M I N N E A P O L I S , M N 5 5 4 0 S I N T E R N A T I O N A L
Offices in all principal
of tha world. Manufacturing in
Australia, Canada, Finland, France,
Japan, Mexico,
Spain,
United Kingdom, U.S.A.
PRINTED IN U.S.A.