Chapter 5 - Servicing
17. In the right pane, ensure that Honeywell LCNP4 appears.
This ensures that the LCNP4E/LCNP4E2 card inserted in PCIe slot 2 is detected.
18. Shutdown the workstation and disconnect the power cable for 30 seconds.
19. Power on the workstation and log in with Administrator privileges for the LCN status and Native
window to function properly.
5.3
Replacing/adding optional components
This section contains procedures for adding or replacing optional components in the workstation.
l
l
5.3.1
Replacing/adding video card
The video card is located in the PCIe slot 4 in the workstation.
To replace/add the video card
1. Perform all the tasks described in section
Accessing the components in the workstation
.
2. Disconnect power from the workstation.
3. Remove the workstation from furniture
4. Disconnect cables from the from the video card.
5. Remove the top cover of the workstation, perform the steps mentioned in section
6. Lift the center riser board to access the LCNP4E/LCNP4E2 board as illustrated in the following
image and remove the riser board from the motherboard.
- 47 -
