Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing
or damaged, contact your dealer immediately.
HBD1PR1/HBD3PR1 True Day/Night Indoor/Outdoor IR Bullet IP Camera
Mounting the Camera
1.
Position the camera so that the screw holes on the base align with the screw holes on the
mounting template and the holes for the wall anchors.
2.
Insert the three self-tapping screws through the holes in the bullet camera’s base, into the wall
anchors, and then tighten them to secure the camera in place.
•
Camera
•
Documentation CD
•
Quick install guide
Required tools:
•
A Phillips screwdriver
•
Self-tapping screws (×3)
•
Plastic wall anchors (×3)
•
Mounting template
Connecting the Wires
1.
Connect the Ethernet cable to the RJ-45 port on the camera.
2.
If the other end of the Ethernet cable is NOT connected to a PoE (Power-over-Ethernet) switch
or NVR, connect the power connector of the camera to a 12 VDC power source.
•
A drill with an appropriately sized drill bit for pre-drilling holes for the screw anchors.
CAUTION
Installation and servicing should be performed only by qualified
and experienced technicians to conform to all local codes and to maintain your
warranty.
Adjusting the Field of View
1.
Using a Phillips screwdriver, loosen but do not remove the locking screw on the mounting
bracket arm.
2.
Adjust the camera to the desired field-of-view angle, and then retighten the locking screw to
secure the camera in place.
Note
When the camera body and mounting bracket are at a 90 degree angle, and the locking screw is
tight, do not rotate the camera body more than 360 degrees.
Logging On to the Camera
Camera connected to a PoE port of the Honeywell Embedded NVR can be configured with the NVR
directly.
To log on to the camera with a PC, install the Honeywell Config Tool from the software and documentation
CD, find the camera and open the web browser with the Honeywell Config Tool. The default user name is
admin (case-sensitive) and the default password is 1234.
Preparing the Mounting Surface
1.
Place the mounting template on the mounting surface where you want to install the camera.
2.
Drill a hole and pull the cables through the mounting surface.
3.
Use the drill to pre-drill holes for the wall anchors, then insert the three wall anchors and
secure them in place.
Document 800-21232V1 – Rev A – 10/2015
© 2015 Honeywell International Inc. All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell. The information in this publication is believed to be accurate in all respects. However,
Honeywell cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
(Asia Pacific only)
1
2
3
4
RJ-45
5
