IDR-2P, -2A & -6A Repeaters User Manual
Installation Guide
12
997-411-000-9, Issue 9
March 2008
2.7
Bezel Kit (option)
The bezel is supplied with a dedicated back
box which has fixing holes, three on the rear
wall and two on each side wall. This procedure
describes fixing using the rear wall fixing holes,
although the procedure can be applied to the
side fixing holes. To install the kit:
1
At the repeater installation location, make a
recess (A) in the vertical surface large enough
for the back box (B) to be fully inserted easily
and without unnecessary force. The size of
the recess must also allow for space required
for cable entry into the back box. With the
bezel (C) still attached to the back box, offer
the assembly to the recess to check for
correct depth and clearance. Repeat this
process until the correct depth and
clearances have been achieved.
2
Support the bezel/back box assembly in the
desired position in the recess and mark the
three screw fixing positions (X) as shown
at left. Remove the assembly from the
recess. Using an appropriate sized drilling
bit, drill and plug three holes to take up to
No. 8 (4mm) wood screws. Alternatively,
use the side fixing holes (Y).
3
Prepare all required knockouts, and fit cable
glands as required (see
CAUTION: To avoid distortion of the back
box when preparing knockouts, place the
appropriate back box face on a supporting
surface (e.g. work bench).
4
Orientate the bezel/back box assembly correctly,
offer it to the recess, then feed the cables through
the glands and take up any excess slack. Secure
the assembly in position using appropriate-sized
screws (D) - do not use countersunk-headed
screws. To avoid distorting the bezel and/or back
box (making it difficult to fit the IDR repeater),
do not over-tighten these screws.
5
After the bezel/back box assembly (E) has been
successfully installed, prepare the IDR repeater
(F) for fitting by preparing knockouts, as required,
for bringing in all cables for termination. Insert
one of the supplied cable grommets (G) into
the upper knockout on the rear wall of the IDR
repeater. Orientate the IDR repeater correctly,
hold the door open and offer the IDR repeater
to the installed bezel/back box assembly. Feed
all cables through the prepared knockouts and
fully insert the IDR repeater into the bezel/back
box aperture. Use the four M4 SEM screws (H)
supplied in the kit to secure the IDR repeater
to the assembly using the four holes (Z).
6
Connect the free end of the earth lead (I)
to the earth connector (J) provided on the
inside of the IDR repeater enclosure (top
left corner). Use a suitable-sized, cross-
headed screwdriver to tighten at earth point
to ensure a good earth connection is made.
1 & 4
2 & 3
2
5 & 6
