| 63
Document 800-26311_ A - April 2020
The
Name
and
Code
fields become active.
2. Make your modifications, then click the green check mark to save.
A message appears confirming that the new site has been
Successfully Updated
.
Deleting a Site Code
Click
to delete a site code.
Configuring Interlocks
An interlock is a programmed connection between two points. The interlock causes an
input point, output point, or group of output points to act in a specified manner when
another input point, output point, or group of output points changes its state. An action on
the trigger point causes a reaction on the reacting component. For example, when a motion
detector (input) detects movement, it causes a horn (output) to sound.
On the Interlocks pane, you can:
•
Create and delete interlocks.
•
Enable or disable existing interlocks.
1. Navigating to the Interlocks interface.
•
Click
Panel Configuration
>
Advanced
>
Interlocks.
Figure 2-33 Interlocks Configuration Tab
Summary of Contents for MPA1
Page 1: ...Document 800 26311_Rev B July 2020 Access Control Unit MPA1 User Guide ...
Page 14: ... 13 Document 800 26311_ A April 2020 This page is intentionally left blank ...
Page 72: ... 75 Document 800 26311_ A April 2020 This page is intentionally left blank ...
Page 100: ...www honeywell com security 104 MPA1 User Guide This page is intentionally left blank ...
