Honeywell MCT404, User Manual

Page: 85 / 166

5. Managing DE Devices using MC Toolkit Software
5.5. Online configuration
Revision 3 MC Toolkit (MCT404) User Manual 73
Summary of Operating Procedures
To access displays for Honeywell DE Transmitters:

Start the MC Toolkit application; the MC TOOLKIT ... display will appear. Refer to 5.1 Starting
MC Toolkit application .

Upload the database from the transmitter. (The
QUICK MONITOR
display will enable viewing of
key parameters before taking the time for database uploading.) The DE MAIN MENU appears.
(Refer to 5.3 MC Toolkit Application Software Display Conventions in this section.)

Select the appropriate display from the
DE MAIN MENU
. (Refer to Table 11 DE Displays / Tasks
Summary in this section, and to the list of DE displays.)
The content of each display is summarized in Table 11.
Note: Only the Basic display is available for the STT 750 Temperature Transmitter.
Table 11 DE Displays / Tasks Summary
Menu Item Task
DEVICE INFO Enter:
Device Type:

Tag ID

Message (in Scratch Pad)
Observe (Read):

Type

Serial Number

Firmware Version
GENERAL Select:

PV Type
Enter:

Comm Mode

Line Filter (STT)

T/C Fault Detect (STT)
Observe (Read):

Failsafe Direction
DE CONFIGURE Select:

PV Units

SV Units

Conformity (ST)

Damping

Sensor Type (STT)

Linear
Enter:

LRV

URV
Observe (Read):

LRL

URL

Span

Sensor Type (ST)
CALIBRATION Enter/Select:

Correct Input (Zero)

Correct Input (LRV)

Correct Input (URV)

Reset Corrects (Zero, LRV,
URV)

Loop Test (Check Analog Output
Level)

Trim DAC Current (Calibrate
output current)

Apply Values (that is, re-range
LRV and URV to PV input)
Observe (Read):

Input at Zero, LRV, and URV

(Verify) Reset Corrects

Loop Current (continuity)

Output Current level (at 0 %,
100%)

Applied values of LRV and URV