RECALIBRATING THE THERMOSTAT
TEMPERATURE ADJUSTMENT
Your thermostat should normally display the correct room
SCREW
temperature.
display,
stat can
as follows:
❑
Make sure the thermostat
has been on for at least 2 hours.
❑
Place an accurate room thermometer near the left side of the
thermostat. Be careful not to touch thermometer or breathe on it.
❑
Open the left door of the thermostat.
•l Locate the temperature adjustment screw.
❑
Use a flat blade screwdriver to turn the screw slightly clock-
wise
to increase, or counterclockwise
to decrease the
indicated emperature.
❑
After each turn, allow the thermostat to stabilize about 30 seconds.
❑
Continue this procedure until the thermostat has the same temperature reading as the room
thermometer.
29
69-8026—2
THE “WAITING” INDICATOR DURING AIR CONDITIONING
To prevent possible damage to your compressor, and to maximize the efficiency of your air
conditioning system, no controls can be activated for approximately 6 minutes after the com-
pressor shuts off. If you try to override the temperature during this time, the display will show
WAITING until the 6 minutes pass.
30
YOUR PERSONAL PROGRAM
Use the table below to plan your schedule before you begin programming. If you are pro-
gramming a different schedule for each day of the week, fill out-a different table for each day.
Desired Temperature
b
Typical Activity
a
Your Start Time
Heating
Cooling
Wake up
Leave home
Arrive home
After dinner
Retire
Extra Nighttime
Set Point (see
page 13)
a
You may program between 2 and 6 typical activity times.
b
You may program up to 8 different heating/cooling temperature combinations over the duration
of a week.
31
69-8026—2