DIRECT DRIVE DAMPER ACTUATOR M847D
3
95C-10905—02
Wiring
See Figure 3 for typical wiring hook-ups of the M847D.
Fig. 3. Typical M847D Hookup.
CHECKOUT
After completing the installation, check that the equipment
operates correctly as follows:
1.
When 24 Vac is applied to the motor leads, the motor
powers to the closed or open position.
2.
When power is removed, the motor releases and spring
returns to the normal position.
If full opening and closing is not achieved, check the lower
adjustment lever is to the extreme left and the upper lever is to
the extreme right. See Fig. 4 (Air Flow Adjustments).
Air Flow Adjustments
NOTE: The following describes the adjustments available
with the actuator installed in the
power closed
mode. If the damper you are installing is to operate in
the
power open
mode, the function of the upper and
lower levers is reversed.
1.
When viewed on end, the lower lever is normally posi-
tioned to the extreme left (See Fig. 4). This position
allows the damper to fully open 90° when de-energized.
2.
To restrict the air flow in the open position, loosen (do
not removed) the wing nut and move the lower lever to
the right until the desired position is reached. Tighten
the wing nut. In the extreme right position the damper
should open approx. 50° with the power off.
3.
The upper lever is normally positioned to the right to
provide complete shut off when the actuator is ener-
gized (See Fig. 4).
4.
If desired, to prevent complete closure of the damper,
loosen (do not remove) the wing nut on the bottom of
the unit and move the upper lever to the left until the
desired position is achieved. Tighten the wing nut. In the
extreme left position the damper should close to approx.
40° with the power on.
5.
If additional rotation is required beyond 90°, an addi-
tional 15° may be obtained by removing the Upper
Lever. To do this, first remove the actuator from the
damper. Remove the wing nut and retaining ring then
remove the levers. Reassemble and install.
Fig. 4. Air Flow Adjustment
2
1
PROVIDE DISCONNECT MEANS AND OVERLOAD PROTECTION AS REQUIRED.
NOMINAL CURRENT 0.32 AMP.
1
2
24 VAC
60 HZ
ZONING SWITCH
OPERATOR
MOTOR
ORANGE
YELLOW
M32381
