Honeywell KS10S, Installation Instruction, Page: 10 / 16

Honeywell GmbH 10 MU1H-1417GE23 R0708
GB
6. Pour salt tablets into the salt supply container
7. Connect transformer to the device
o Remove cover to the salt container and hood
o Plug the cable shoes of the transformer into the
controller
8. Replace hood and cover, guide the cable out of the
back of the device
9. Connect the softening device to the mains via the
transformer
10.Programming the softening device
10. Programming the softening device
10.1 Display and operating keys
10.2 Basic settings for commissioning - time, raw
water hardness and regeneration time
1. There is a connection to the power supply
o Display Current time flashes
2. Set the time by pressing + or -
3. Confirm with MENU / OK
o Display Hardness flashes
4. Set the raw water hardness by pressing + or -
5. Confirm with MENU / OK
o Display Regeneration time flashes
6. Set the desired time for the regeneration by pres-
sing + or -
o Recommended time 2:00
7. Confirm with MENU / OK
8. Starting regeneration
o Press the Regeneration key for 5 seconds
o Display
Regeneration active flashes
o The time is displayed in the display during the
regeneration process
9. After the end of the regeneration (duration 45
minutes)
o Display
Regeneration active goes out.
o The time is displayed
10.The device is ready for operation
10.3 Setting the mix water hardness
1. Setting the mix water hardness by turning the screw
at the base of the diluting device
o Use screwdriver
o Turn counter-clockwise = increase water hard-
ness on output side
o Turn clockwise = decrease water hardness on
output side
2. Check the mix water hardness at a tapping point
o Open tapping point completely to ensure sufficient
flow
3. Readjust by turning the screw if necessary
Use only salt tablets acc. DIN 19604.
The hardness of the raw water can be inquired
from the water distribution company.
AKTUELLE ZEIT
REGENERATION MENU / OK
AKTUELLE ZEIT
HÄRTE
REGENERATION
ZEIT
It is recommended to set a residual water hard-
ness of at least 8°dH to avoid corrosion
damages.
It is recommended to check the output water
hardness regularly (2 times a year).
REGENERATION AKTIV