Honeywell IdentIPoint Intelligent Smartcard Readers
3. Route the field wiring including the Ethernet
cable (if required) from the conduits into the
gang-box. Clip the square ferrite clip on the
reader’s Ethernet pigtail. See
Fig.6
.
Connect the field wiring to the correct
Molex pigtails. See
Fig.5
. For reader
connection details see
Fig.10
. Route the
Molex terminal(s) through the cable
opening on the back-plate towards the front
of the mounting surface (see
Fig.5
) and
plug them in ports J9 and J10 at the back
of the reader. See
Fig.6
. Clip (with two
turns wrapped) the round ferrite clip on the
field Ethernet cable. See
Fig.5
. Plug the
RJ45 connector of the field Ethernet cable
into the Ethernet port of the reader
provided at the end of the pigtail.
Accommodate the Molex and Ethernet
pigtails inside the gang-box. Set the S1 DIP
switch if the reader is to be connected to an
IOM via RS485. See
Fig.10
and appendix
for more details.
4. Once all the connections and settings are
done, hold the reader against the back-
plate, aligning the mounting slots at the
back of the reader with their corresponding
catches on the back-plate and push it
downwards until it hooks into place firmly.
See
Fig.7
and
Fig.8
.
5. Use the Allen wrench to tighten the tamper-
resistant screw at the bottom of the reader.
See
Fig.9
.
Fig.1. Parts of IdentIPoint
reader – Front of reader and
Back-plate
BACK-PLATE
CATCHES FOR
HOLDING READER
ON BACK-PLATE (4)
READER
STATUS LED
KEYPAD
READER FRONT
MOUNTING SCREW
HOLES (10)
OPENING FOR
ROUTING CABLES (1)
1
2
3
4
5
6
7
8
9
0
#
LCD
BACK-PLATE
CATCHES FOR
HOLDING READER
ON BACK-PLATE (4)
READER
STATUS LED
KEYPAD
READER FRONT
MOUNTING SCREW
HOLES (10)
OPENING FOR
ROUTING CABLES (1)
LCD
1
2
3
4
5
6
7
8
9
0
#
1
2
3
4
5
6
7
8
9
0
#
95-7771
4
