HTR1 Quick Start Guide
Document
800-00760
Rev
A
11/07
© 2007 Honeywell International Inc.
Video Systems
www.honeywellvideo.com
+1.800.796.CCTV (North America only)
All rights reserved. No part of this publication may be reproduced by any means without written permission from Honeywell Video Systems. The information in this publication is believed to be
accurate in all respects. However, Honeywell Video Systems cannot assume responsibility for any consequences resulting from the use thereof. The information contained herein is subject to
change without notice. Revisions or new editions to this publication may be issued to incorporate such changes.
Specifications subject to change without
notice. Imperial conversions are approximate.
2
Programming the VCR
1.
Install the two AAA/UM4 (size E92) batteries (supplied) into the
remote control.
2.
Remove or open access panel on enclosure cover.
3.
Plug RCA cable into
VIDEO OUT
jack on front of VCR. Plug other
end into
VIDEO IN
jack of a portable monitor.
Start vehicle. Press
MENU
on the remote control to enter the Program
mode. To apply temporary power to program the VCR without turning
the bus ignition on, use the VCR POWER button.
User configurable settings
You can change any of the pre-configured factory settings shown
below.
Turns unit off
Program mode
S
T
Play mode
Ejects VCR tape
Video tracking
Rewind tape/search images
Playback video
Playback images fast forward
Pause
ST
WW
X
XX
Move cursor left
Move cursor right
Enter/exit Program mode
TRK
TRK
Change value
Select action
Display or exit Menu
UP/DOWN
ENTER
MENU
Playback or Record mode
Change Rec and Play
REC/PLAY
HOURS
Stop playback or recording
Record video
and character
speeds (EP or SP)
Text line (up to 20 characters)
Reset/restore defaults
Record speed
5 Trigger
4 Daily
Recording mode
Record stop delay (0-54 mins)
Current time, date
= Feature is enabled
= Parameter is disabled
For example, Bus ID
DST = Daylight Saving Time on/off
and DST indicator
indicators
Selected trigger is active
Selected trigger is inactive
timers
XXXXXXXXXXXXXXXXXXX
10:09:07
DT 1/ 7/2008
BRK
STP
TRN
FSH
ARM
00 00 EP
MPH
12:00
12:00
12:00
12:00
12:00
12:00
12:00
12:00
Speed in MPH or KPH
GPS direction
GPS latitude/longitude
Start Delay (0-60 mins)
Bus ID on/off
Bus ID String
4.
Press
MENU
to exit Program mode, then
POWER
on front of VCR
to start recording.
3
Daily operation
Legend: Status Indicators Daily Timers
= Parameter is enabled
= Parameter is disabled
BRK
= Input enabled; system will display
= Display is active when input is 12 volts OR
= Unit does not switch camera inputs.
= Unit switches inputs (e.g., to Stop Arm camera)
Note
Make sure all
timers are disabled ( )
if not used.
= Display is active when input is grounded
POWER
= Turns VCR on for temporary power
EJECT
= Press to eject tape
REW
= Rewind tape, search backward through images
PLAY
= Play back tape
FF
= Advance tape or search forward through images
STOP
= Stop recording
REC
= Press to record
POWER Indicator = Lights when the HTR1 is plugged into a power source
EP Indicator
= Lights when the HTR1 is in EP mode
REC Indicator
= Lights when the HTR1 is recording
Legend:
Receives
infrared signals
from remote
control
Tool text tip line provides setting descriptions
