Honeywell HRXDS16, User Manual

Page: 69 / 172

Document 800-04559 Rev D 69
11/09
Configuration
Figure 3-36 Camera PTZ Setup Screen
Note You will only be able to set up PTZ devices if the PTZ port is set
to RS232 or RS485.
2. Highlight the box in the Product column for the PTZ camera you wish to
configure, then press
#
. A list of PTZ devices appears.
3. Select your camera from the list, then press
#
. You must connect the camera to
the RS232 or RS485 connector on the back of the DVR following the camera
manufacturer's instructions.
Figure 3-37 PTZ Device List
4. To assign IDs to each camera, highlight the appropriate box under the ID heading,
then press
#
. Change the number by highlighting it and using the Up and Down
arrow buttons to increase and decrease the number. The PTZ ID number can be
set from 0 to 256.
5. Highlight the Setup… box, then press
#
. The Port Setup window appears (see
Figure 3-38 ).