Honeywell HREP216, User Manual

Page: 85 / 200

800-15802 - A - 12/2013
System Setup | 85
CAUTION
If you proceed with the firmware upgrade or select to
reset to the factory default, all current settings of the DVR will be erased.
In such a case, you must configure the network, time and recording
settings again.
• SYSTEM DATA : Save the system settings or get the system information from another
device.
• SAVE : Store the DVR settings to a storage device. Connect the storage device to
the USB port of DVR.
• LOAD : Apply the settings of the storage device to the DVR. Connect the storage
device to the DVR USB port (see Figure 4-35 ).
Figure 4-35 System Management Loading System Data
• PASSWORD : Open or close the dialog box for settings of the menus: quit, system
settings, record settings, backup, and search.
CAUTION
If it is set to Off, note that the ADMIN account is only
effective and access to all menus will be restricted.
• EXPIRED TERM OF PASSWORD : You will be prompted to change the current
password after a certain period of time.
• AUTO LOGOUT : If there is no user input for a certain period of time, you can set to
log out automatically.
• WAIT TIME : Specify the waiting time for Auto Logout.
3. When finished, press the EXIT button on the remote control or click CLOSE in the lower
part of the screen to return to the previous menu.
Upgrading Firmware
1. Connect the USB storage device that contains the upgrade files to the DVR.