Rev. 1.01
37
900.0570
8-Sept-05
HONEYWELL DIAMOND PROTOCOL, CONTINUED
7.8 PRESHOT SEEK
To seek preshot 1:
1. Press key ‘1’.
2. Press the ‘preset’ key.
Preshots 1 to 4 can also be selected by single key presses using the keys labelled
‘preset’ ‘1’ to ‘4’.
If a preshot seek is attempted for a preshot number which has not been defined, the
dome will not move, and the message “Does Not Exist” will be displayed on screen.
Note
: Preshots can also be selected using the OSD menus
7.9 VECTORSCAN SELECTION
Up to 10 vectorscans can be selected numbered 0 to 9.
To recall a vectorscan 1:
1. Press key ‘1’.
2. Press the ‘autopan’ key.
If a vectorscan is selected which has not been defined, the dome will not move, and the
message “Does Not Exist” will be displayed on screen.
Note
. Vectorscans can also be selected using the OSD menus. Vectorscans can only be
programmed using the OSD menus
7.10 FREEZE
Press
and hold
‘Fn’, then press ’F2’ (‘
▼’
)
or ‘freeze’ to toggle the camera between
freeze mode on and freeze mode off.
7.11 FLASHBACK
Press
and hold
‘Fn’, then press ‘F3’ (‘
◄’
)
or just press ‘auto 180’ to operate the
flashback function.
