Honeywell HD32X, User Manual

Page: 6 / 24

6
• The timer option on the left of the control panel (see Fig. 5) allows you to select
how long the unit will run before it turns off automatically.
• ‘Tap’ the Timer symbol ( ) to shift through the options. When pressed the time
will move to the next highest setting until it is on ‘12’ (which means it will stay
on for 12 hours and then shut-off). If you tap the Timer symbol while it is on
‘12’ the timer option will turn off and the unit will run continuously. If you ‘tap’ it
again, it will start back at ‘2’.
• Toggle through the hour options until the LED light is illuminated behind the
number of hours you want the unit to operate for. If the Auto-off Timer is not
illuminated, the air purifier will run continuously.
SETTING THE TIMER OPTION
Fig. 5
ELECTRONIC FILTER CLEAN REMINDER
• This model air cleaner has an electronic filter check to remind you when to
check the washable ifD
®
filter based on the air purifier’s hours of use.
• When the ifD
®
filter needs to be cleaned, the LED light ‘bar’ will remain full and
the light will be illuminated until it is RESET. You may unplug the air cleaner
without interrupting the filter check.
• You should periodically check the filter. Depending on operating conditions,
the filter should be cleaned at least once every three months.
To RESET the Electronic Filter Check:
• When the filter monitor light remains on, it is time to check/clean the
ifD
®
filter and reset the filter monitor, if needed.
• After the filter has been cleaned and placed back in the unit (dry), you will want
to reset the indicator. To do this, ‘touch’ the ‘OK’ button for 2 or more seconds
until the LED light is off and the fill ‘chart’ is not illuminated.
Fig. 6
Fig. 7
REMOVING THE FILTER
CAUTION: Turn off the unit and wait 60 seconds before removing
the grille to clean filters.
The ifD
®
filter is supplied within the air cleaner.
• Turn-off the air cleaner. Wait 60 seconds and unplug the unit before removing
the grille. While pressing down on the notch along the rear grille, pull the grille
down and towards you and remove it (Fig. 8). Gently push along the edge of
the filter frame and pull forward.
• To place the filter back into the air cleaner housing, insert at the bottom and ensure that it is pushed in as
far as it can go, then push in from the top. To replace filter grille, align pin on bottom of grille with opening
on the housing and snap back into place. If the filter grille is not properly inserted, your air purifier may
not turn on. Ensure it is properly installed and there is no gap between grille and the housing.
NOTE:
If the odor reducing pre-filter is used in lieu of the permanent washable pre-filter, it will need to be
replaced approximately every 3 months.
Fig. 8