4
1. POWER SWITCH
Press to turn the monitor ON. The POWER LAMP above the switch will illuminate.
2. VOLUME
Adjust the VOLUME control for the desired audio level. Turn the control clockwise to increase and
counterclockwise to decrease.
3. CONTRAST
Adjust the CONTRAST control for the desired overall contrast. Proper adjustment will allow maximum
gradations between the darkest and lightest picture areas. Turn the control clockwise to increase and
counterclockwise to decrease.
4. BRIGHTNESS
Adjust the BRIGHTNESS control for the desired overall display brightness. This control is also useful
to compensate for differences in area lighting. Turn the control clockwise to increase and counter-
clockwise to decrease.
5. COLOR
Adjust the COLOR control to set the color saturation level. Turn the control clockwise to increase and
counterclockwise to decrease.
6. SHARPNESS
Adjust the SHARPNESS control to obtain a clearer picture.
7. TINT
Adjust the TINT control for the proper color phase or flesh tones. When turned counterclockwise, the
skin tone becomes reddish. When turned clockwise, skin tone becomes greenish.
8. POWER LED LAMP
Power lamp indicates the power is on.
9. POWER INLET
Please use AC 100-240V, 50/60Hz.
To prevent electrical shocks and fire hazards, do not use any other power source.
10. IMPEDANCE SWITCH
Set the switch to the HIGH position if another monitor is connected to the VIDEO OUTPUT on the
rear of the monitor. The last monitor should be set in the 75
position.
Set the switch to the 75
position if the VIDEO OUTPUT is not used.
11. S-VHS/CAMERA SWITCH
Set the switch to S-VHS(VIDEO) if you want to see the higher resolution S-VHS as the VIDEO.
Set the switch to CAMERA if input signal is camera signal.
12. S-VHS JACK
If you want to see the S-VHS(VIDEO), please connect directly to this jack.
13.14. AUDIO INPUT&OUTPUT CONNECTOR
Connect an RCA cable between these jacks and the audio jack of a camera or VCR.
15.16. VIDEO INPUT&OUTPUT CONNECTORS
These BNC connectors permit loop-through connection of a video signal in those installations
where it is desirable to display the video signal on more than one monitor. A standard 1. 0Vp-p video
signal applied to the VIDEO INPUT will also appear at the VIDEO OUTPUT. Use coaxial cables with
BNC type plugs for these connections.
LOCATION AND OPERATION OF CONTROLS
