Honeywell First Alert FA148CP, User Manual

Page: 40 / 64

– 40 –
Trouble Conditions (Continued) Trouble Conditions (Continued) Trouble Conditions (Continued) Trouble Conditions (Continued)
Words or letters in parentheses ( ) are those that are
displayed on Alpha Display keypads.
Other Trouble
Displays
*
Any “beeping” that
accompanies a trouble
display can be stopped
by depressing any key
on the keypad or by
entering an OFF
sequence (code + OFF)
**
Not all systems use
wireless sensors.
COMM. FAILURE Indicates that a failure has occurred in
(or FC ) the telephone communication portion of
your system. CALL FOR SERVICE.
SYSTEM LO BAT Indicates that a low system battery
(or BAT with no condition exists. Display is
zone No.) accompanied by "beeping"* at the
keypad. If this condition persists for
more than one day (with AC present),
CALL FOR SERVICE.
LO BAT Indicates that there is a low battery
+ zone descriptor condition in the wireless transmitter**
(or BAT with number displayed (00 is RF keypad).
zone No.) Accompanied by a single "beep"* (about
once every 30 seconds) at the keypad.
Either replace the battery yourself, or
CALL FOR SERVICE. If the battery is
not replaced within 30 days, a
CHECK
display may occur.
Rcvr Jam Wireless part of the system is experiencing
(or CHECK 90 ) RF interference which may impede
reception from wireless sensors.**
ALARM 1xx
FAULT 1xx
CHECK 1xx
(or 91 )
Indicates a communication problem
between the control and a connected
device (e.g., RF receiver, zone expander)
where the “xx” indicates the device
address. CALL FOR SERVICE.
MODEM COMM
(or CC )
Indicates that the control is on-line with
the Central Monitoring Station's remote
computer.
The control will not report system
activity while on-line. Wait a few minutes
— the display should disappear.
BELL FAILURE Indicates that the wiring connection to
(or CHECK 70 ) the external sounder is at fault (open or
shorted). Accompanied by “beeping” at
the keypad. CALL FOR SERVICE.