Honeywell EQUIP HD4HDIH, User Manual, Page: 22 / 90

22
Installation and Setup
Step 4. Installing the Conduit Plug
Your camera enclosure base comes with a conduit plug pre-installed in the 3/4 inch conduit
entry on the back. To use the back conduit entry, remove the conduit plug and install it in
the side conduit entry after loosening the locking screw (see
Figure 2-4
)
. Retighten the
locking screw to secure the conduit plug in place.
Figure 2-4 Conduit Plug Installation
WARNING! To minimize moisture leaking into the camera housing when
mounting your camera on a vertical surface, position the
enclosure with the side conduit entry pointing down. After
feeding the cables through (see
Step 7. Connecting the
Wiring , page 23 ), apply an appropriate sealant around the
conduit connection.
Step 5. Installing the Grommet (optional)
If a conduit is not used for cable routing, install the rubber grommet in the conduit hole (in
the camera base), then slit the grommet and feed the cables through (see
Step 7.
Connecting the Wiring , page 23 ). Use the appropriate sealant to seal the grommet to
prevent moisture from entering the housing.
Conduit plug
Back entry conduit
Side entry conduit
Conduit plug locking screw
Enclosure base
Screw
Rubber washer