Honeywell EQUIP HD4HDIH, User Manual

Page: 21 / 90

HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
Document 800-07496V2 Rev A 21
11/2011
Step 3. Preparing the Mounting Surface
1. Affix the mounting template (supplied in the camera box) to the mounting surface or
use the back of the camera base, as shown below, to trace the screw holes.
Note The housing is intended for mounting on a flat surface only.
Figure 2-3 Tracing the Camera Base
Note To prevent moisture from entering the housing, position the enclosure with
the side conduit entry pointing down if you are mounting the camera on a wall
or other vertical surface.
2. Pre-drill three holes as indicated on the template, using the recommended hole size
for the screws being used.
3. Drill out the conduit hole, if required (see Step 4. Installing the Conduit Plug , page 22 ).
Note Alternate fasteners (preferably stainless steel) can be used, provided they are
not larger than the screw holes on the mounting template.